These rods can be easily replaced in about 15 minutes.
Top load washing machine shakes violently spin cycle.
Unbalanced washer the spin speed of an average washing machine is between 600 1400rpm.
When shock absorbers weaken or become damaged unbalanced loads will cause the washer to shake or move and the machine will often make a loud banging sound during the spin cycle.
All front load washing machines have shock absorbers that are used to dampen the tub movement in the spin cycle.
Samsung washers use vrt technology vibration reduction technology.
These springs are used to suspend the basket from the frame.
If they are broken or damaged however the washing machine may shake violently when it enters the spin cycle.
This is a normal part of the process of cleaning your clothes.
As it pauses and vibrates it checks the load balance and then the vrt technology identifies the spot where the load is unbalanced.
Redistributing the load will usually solve this issue if the cause is due to too many clothes on one side of the unit.
Adding one or more towels or redistributing the weight and resetting the washer can often solve this problem.
With vrt when the washer spin cycle reaches approximately 400 rpm it pauses and vibrates for a few moments.
When your whirlpool washer goes into the spin cycle to remove the water from the laundry there is usually some noise and slight vibration.
Open the door to inspect the arrangement of your clothes.
Vrt is a system that samsung has developed to reduce high rpm vibrations drastically.
A single large wet item such as a comforter or blanket can hug one side of the washer during the spin throwing the washer off balance and causing it to vibrate.
If your washer starts shaking during the spin cycle pause the washing machine.
Assuming you have a front loading washing machine recommended for energy efficiency you can access the suspension springs through the top panel.
Spread your clothes out and resume your spin cycle.
However when the machine begins to vibrate and shake violently causing a loud disturbance it is a problem that could damage your machine or floors.
The shock absorbers or struts are attached to the base frame and to the outer tub and you will need to remove the front panel or the rear panel to access them.