Tongue And Groove Wood Flooring Installation

Cut off the tongue if it is on the edge that meets the obstruction.

Tongue and groove wood flooring installation.

The glue must be placed along the topside of the groove the full length of the grooved side and end. Although tongue and groove solid hardwood flooring does fit together it must still be nailed to a subfloor. Engineered tongue and groove planks however snap together to create a floating floor. Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the joint.

If so miter boards to create a border that frames the obstruction. Position the boards so the tongue or groove mates with the rest of the floorboards. Glue placement is very important. Installing tongue and groove floors engineered pre finished or bare wood is among the most popular diy projects and for good reason.

Begin laying flooring from the wall measure one board width and snap a chalk line. Install the rest of the floor as you normally would fitting the pieces into the frame as you go. For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board. Prep layout installation and finishing tips for tongue and groove floors.