Gas lift bed frame installation guide.
Tommy lift installation instructions.
Do not exceed the rated lift.
Installation of tommy docks in water first year only.
Tommy gate or an authorized distributor for assistance.
Do not exceed the rated lift decal no.
Walk out to bracket locations loosen bracket adjusting bolt.
Needed call tommy gate use only tommy gate do not modify lift or its safety service parts installed by an warning read operator s manual before operating equipment.
Warning do not bend safety bar located on box cover of gate.
Refer to the installation instructions for more cutting details.
8 located on the control shield.
Installation instructions tommy gate tkl 2500 lb capacity woodbine iowa dpn.
Tommy lift woodbine manufacturing co.
Remove winch and go to the next post leg.
How to operate a tommy lift on our box truck.
Install all pins post bumpers optional and safety caps.
Introduction page to the installer operator 3 safety decals and tuckunder description safety decal location and descriptions 4 5.
Parts list 66 x bolt a 70 for king size 10 x bolt b 14 for king size 4 x corner connector 4 x corner legs 10 x nuts 14 for king size parts list continued 4 x bracket a 2 x bracket b 1 x bracket d 2 x support legs 4 for king size.
Let pipe slide down to lake bottom then tighten bracket adjusting bolt.
Refer to available option sheet for bumper installation.
095266 page 1 of 32 rev 4 7 15 19 tommy gate the original hydraulic lift n.
Possible injury or death.
If an instruction or illustration.
Slide styrofoam log under far end of section and float into position.
2929 caution maximum outrail ground clearance for this bed height rail gate is 28.
Use only tommy gate do not modify lift or its safety service parts installed by an warning read operator s manual before operating equipment.
Accident prevention and safety are dependent upon the awareness concern prudence and warning caution danger to the owner operator note.
Drill all holes for assembly pins.
While on shore install brackets posts and foot pads.
Lift or lower dock to level then tighten dock bracket adjusting hex bolt.