The most common problem for a toilet shut off valve is that it can develop a leak.
Toilet water turn off valve leaking.
The water valve stem passes through a packing nut and washer which provide a watertight seal.
This valve usually is in the basement or a utility closet and it will be clearly labeled.
There s an easy way to fix it and you may want to give it a try.
Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work.
How to replace a.
Is probably occurring around the water valve stem.
How to fix a shutoff valve leak.
Then follow our step by step instructions on our article.
You can do this by turning the valve by the toilet base clockwise.
Turn back the water supply and check if there are any leaks on the toilet shut off poppet.
Turn on all the faucets and flush all the toilets associated with the main shutoff valve to empty the pipes of water.
If the water valve looks rusty or is difficult to turn try applying some wd 40 to it.
Then flush the toilet to empty the tank.
Unscrew the handle the packing nut and the threaded valve stem photo 2.
Place the small container underneath the valve in case some water leaks into it while you do the repairs.
Before you remove the toilet shut off valve you ll need to drain the supply line to prevent the water remaining in the pipe from gushing out onto your bathroom floor.
Dripping shut off valves can leave puddles of water on the bathroom floor which can ruin the flooring make the room look dirty destroy bathroom furniture cause mold and mildew to grow and run up your water bill.
Support see jane dri.
It s not uncommon for a brand new shut off valve to leak around the handle area whenever you turn it on.
If the toilet water shut off valve is not working sometimes the problem lies on the inlet coming from the toilet line of the shut off poppet.
If none you have done it right.
If your water supply valve is leaking you may not need to replace it.
For a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench.
When you re ready to get started shut off the water.
Turn off the water at the house s main shutoff then disassemble the problematic shutoff valve without disconnecting the valve from either the water supply line or the line leading to the toilet.
Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
Turning the valve clockwise as far as it can go will turn off the water supply to the toilet.
The valve should not be difficult to turn so don t try to force it if you can t easily turn it.
Do not remove the valve just tighten the packing nut.