According to the national kitchen and bath association nkba the code requirement for the minimum space between a wall or other appliance and the center line of a toilet or bidet is 15 inches.
Toilet and bidet spacing.
Toilets and bidets.
Each has a minimum space allowance to pass code.
Fixtures are defined as any large permanent addition to the bathroom tub toilet vanity sink bidet or shower.
A toilet requires a minimum 30.
To properly fit se400 se600 is707 cl510 ds725 and cl950 models this distance must be 5 1 2 inches.
According to the national kitchen and bath association nkba the code requirement for the minimum space between a wall or other appliance and the centre line of a toilet or bidet is 37 5 cm 15 inches.
The nkba actually recommends 32 inches there should be at least 24 inches of clear space in front of a toilet or bidet.
It s typically going to be a 10 inch rough in size 12 inch or 14 inch rough in toilet.
Moreover the nkba recommends 32 inches from the center of the toilet waste line to the center of.
The space must be between 5 1 4 inches and 8 inches.
Your new toilet may be one piece a two piece or an all in one.
Most codes require at least 15 inches measured from the center of the toilet from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture.
One of the first things to consider when shopping for a toilet is the rough in size.
The nkba however recommends 18 inches rather than 15 inches to give users more space.
15 inches to the nearest side wall partition or fixture recommended.
If mounted on the wall the toilet roll holder will need several inches of extra space as well.
There must be at least 1 inches of clearance.
18 inches to the nearest side wall partition or fixture.
A minimum distance of 15 inches is required from the centerline of a toilet and or bidet to any bath fixture wall or other obstacle.
The national kitchen bath association requires at least 24 inches clearance in front of a toilet.
This means that if they share an enclosure its minimum width will be 62 1 2 inches 3 times 18 inches plus an 8 1 2 inch allowance for half the width of the bidet.
That s the distance between the wall and the center of the floor drain.
The nkba however recommends 45 cm 18 inches rather than 37 5 cm 15 inches to give users more space.